Flexible DRL LED Kit - 2 Strips Pack No Disassembling Needed

In addition to its good-looking appearance, the installation of daytime running light strips can reduce the traffic accident rate by 12.4% and the death rate by 26.4%. This is legal and safe. 

• Suitable for any car model
• Easy to install without disassembly the headlights
• Non-flammable fire retardant burn
• Silicone material with good seal, waterproof , energy saving, anti-corrosion.
• Daytime running light strips are different from high beam, NO GLARE.

• Only 4mm thick, can be installed in the gap between the Headlights and the Engine Hood with adhesive tape, no drilling, no screwing and no disassembling needed.

• Lights are white when turn signal light is off, then the lights flow yellow when turn signal light is switched on.
• Handpicked SMD-3014 LEDs, no dead light and dark spots, brighter than the stock halogen headlight bulbs. It's a good replacement light for car original headlight.
• Unlike old designs where the DRL and Turn Signal share the IC Controller, these lights have separate IC Controllers which guarantee stability.
• Faster on/off response time and vibration resistant

• Power off during your customizing installation
  
• Cut down the strip along the line.
  
• Make sure no debris gets in.
  
• Sealing the tube with insulated glue after cutting in short.

 Installation：

 Easy Installation, just require right connect to positive and negative side

• Red wire: Power Positive(+)
• Black wire: Power Negative(-)/Ground
• Yellow wire: Left or Right Turn Signal Positive(+)

Universal fit for all 12V auto vehicle, commonly used for Car, SUV, Vans, Truck, RV, Motorcycle, Scooter, Trailer etc.

• Material: Soft Rubber Tube.
• Input Voltage: 12V
• Power Rating: 5.5W
• Lifespan: 50,000 hours
• Working Temperature: -40-60 ℃
• Length: 60cm(23.62in).

•     2 x LED Strip
•     2 x Adapter Wire
•     1 x Instruction Manual

• Please test the lights to ensure they are working before proceeding with any type of work.
• Don't stress the cables or bent too much when you try to open the headlight to install them.